DietPi VisionFive 2 Test Report

Test Environment

Operating System Information

System Version: v9.7.1 (MichaIng/master)
Download Link: https://dietpi.com/downloads/images/testing/DietPi_VisionFive2-RISC-V-Sid.img.xz
Reference Installation Document: https://dietpi.com/blog/?p=2629

Hardware Information

StarFive VisionFive 2
A USB Power Adapter
A USB-A to C or C to C Cable
A microSD Card
A USB to UART Debugger (e.g., CH340, CH341, FT2232, etc.)
Three Dupont Wires

Installation Steps

Decompress and Flash Image to microSD Card

xz -d DietPi_VisionFive2-RISC-V-Sid.img.xz
dd if=DietPi_VisionFive2-RISC-V-Sid.img of=/dev/<your-device>

Boot Mode Selection

StarFive VisionFive 2 offers various boot modes, which can be configured via onboard dip switches before powering on; there are also silk screen labels on the development board itself.

To boot the Dietpi image, you can select the 1-bit QSPI Nor Flash mode (i.e., RGPIO_0 = 0, RGPIO_1 = 0). Note that this mode may require a prior firmware update in the Flash. If your boot is unsuccessful, please refer to the official documentation for firmware upgrading: Update SPL and U-Boot

Logging into the System

Logging into the system via the serial port.

Username: root Default Password: dietpi

Expected Results

The system boots normally and allows login via the serial port.

Actual Results

The system booted normally and login via the serial port was successful.

Boot Log

Debian GNU/Linux trixie/sid DietPi ttyS0

DietPi login: root
Password: 
Linux DietPi 6.1.97 #1 SMP Fri Jul  5 23:02:10 UTC 2024 riscv64

The programs included with the Debian GNU/Linux system are free software;
the exact distribution terms for each program are described in the
individual files in /usr/share/doc/*/copyright.

Debian GNU/Linux comes with ABSOLUTELY NO WARRANTY, to the extent
permitted by applicable law.
 ─────────────────────────────────────────────────────
 DietPi v9.7.1 : 14:51 - Fri 10/25/24
 ─────────────────────────────────────────────────────
 - LAN IP : 192.168.31.87 (eth0)

 DietPi-Update
─────────────────────────────────────────────────────
 Phase: Checking for available DietPi update

[  OK  ] DietPi-Update | Checking IPv4 network connectivity
[  OK  ] DietPi-Update | Checking DNS resolver
[  OK  ] DietPi-TimeSync | systemctl start systemd-timesyncd
[ INFO ] DietPi-TimeSync | Waiting for time sync (1/60)
[ INFO ] DietPi-TimeSync | Waiting for time sync (2/60)
[ INFO ] DietPi-TimeSync | Waiting for time sync (3/60)
[ INFO ] DietPi-TimeSync | Waiting for time sync (4/60)
[ INFO ] DietPi-TimeSync | Waiting for time sync (5/60)
[ INFO ] DietPi-TimeSync | Waiting for time sync (6/60)
[ INFO ] DietPi-TimeSync | Waiting for time sync (7/60)
[  OK  ] DietPi-TimeSync | Time sync completed
[  OK  ] DietPi-TimeSync | systemctl stop systemd-timesyncd
[  OK  ] DietPi-TimeSync | mkdir -p /run/systemd/timesync
[ INFO ] DietPi-Update | Getting latest version from: https://raw.githubusercontent.com/MichaIng/DietPi/master/.update/version
[  OK  ] DietPi-Update | Got valid latest version: 9.8.0
[  OK  ] DietPi-Update | Update available:
[ INFO ] DietPi-Update | Current version : v9.7.1
[ INFO ] DietPi-Update | Latest version  : v9.8.0

 DietPi-Update
─────────────────────────────────────────────────────
 Phase: Checking for update pre-requirements

[  OK  ] DietPi-Update | DietPi-Userdata validation: /mnt/dietpi_userdata
[  OK  ] DietPi-Update | Free space check: path=/ | available=28171 MiB | required=100 MiB
[ SUB1 ] DietPi-Services > stop 
[  OK  ] DietPi-Services | stop : cron

 DietPi-Update
─────────────────────────────────────────────────────
 Phase: Applying pre-patches

[  OK  ] DietPi-Update | Downloading pre-patches
[  OK  ] DietPi-Update | Applying execute permission
[  OK  ] DietPi-Update | Successfully applied pre-patches

 DietPi-Update
StarFive VisionFive 2 (riscv64) | IP: 192.168.31.87 | Use up/down buttons to scr
│ APT update
│  - Command: apt-get -y -eany update
│  - Exit code: 100
│  - DietPi version: v9.7.1 (MichaIng/master) | HW_MODEL: 81 | HW_ARCH: 11 |
│ DISTRO: 8
root@DietPi:~# cat /etc/os-release 
PRETTY_NAME="Debian GNU/Linux trixie/sid"
NAME="Debian GNU/Linux"
VERSION_CODENAME=trixie
ID=debian
HOME_URL="https://www.debian.org/"
SUPPORT_URL="https://www.debian.org/support"
BUG_REPORT_URL="https://bugs.debian.org/"
root@DietPi:~# uname -a 
Linux DietPi 6.1.97 #1 SMP Fri Jul  5 23:02:10 UTC 2024 riscv64 GNU/Linux

Screen recording (logging into the system):

Test Criteria

Successful: The actual result matches the expected result.

Failed: The actual result does not match the expected result.

Test Conclusion

Test successful.

System Version

Status

Last Update